Microstructure and texture evolution during thermomechanical processing of β-quenched Zr
نویسندگان
چکیده
منابع مشابه
Microstructure Evolution during Electric Current Induced Thermomechanical Fatigue of Interconnects
We demonstrate the evolution of microstructure and deformation associated with the use of electrical methods for evaluating mechanical reliability of patterned interconnects on rigid substrates. Thermomechanical fatigue in aluminum and copper interconnects was induced by means of low frequency (100 Hz), high density (> 10 MA/cm) alternating currents, which caused cyclic Joule heating and associ...
متن کاملThe effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy
An AM30 magnesium alloy was processed through ECAP method at 200 °C. Optical and transmission electron microscopy as well as electron back scattered diffraction (EBSD) technique were employed to characterize the deformed microstructure. A partially recrystallized microstructure including ultrafine/nano structures was obtained. The area fraction of 49% was measured for the recrystallized regions...
متن کاملUltrasonic characterization of microstructure evolution during processing
Ultrasonic characterization of microstructure evolution during processing" (2007). Many cold-working processes for polycrystalline metals cause alignment of the grains with a single symmetry axis. This type of microstructure is called fiber texture. The existence of a preferred orientation of the grains has a significant influence on the propagation and scattering of ultrasonic waves, which are...
متن کاملEffect of Thermomechanical Processing on the Microstructure and Mechanical Properties of a Duplex Stainless Steel
Duplex stainless steels (DSSS) have a microstructure composed of ferrite and austenite phases that gives them a very good combination of mechanical and corrosion properties. These steels are desirable for many applications in the chemical and petrochemical industries. In the present study, a type of stainless steel was cast, solution annealed at 1200°C for 60 min and then quenched in water. Ini...
متن کاملEvolution of microstructure and texture during recovery and recrystallization in heavily rolled aluminum
The annealing behavior of nanostructured aluminum AA1050 prepared by cold rolling to an ultrahigh strain (vM = 6.4) has been investigated using both transmission electron microscopy and electron backscatter diffraction techniques, paying particular attention to changes in microstructure and texture during recovery and their influence on subsequent recrystallization. It is found that coarsening...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2015
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2014.12.033