Microstructure Characteristics of ECAP Processed 1050 Aluminum After Deformation and 5 Years Later
نویسندگان
چکیده
منابع مشابه
Microstructure Evolution in High Purity Aluminum Single Crystal Processed by Equal Channel Angular Pressing (ECAP)
Aluminum single crystal with 99.999% purity was deformed at room temperature by equal channel angular pressing (ECAP) up to 16 passes. Grain size and misorientation of processed samples were quantitatively characterized by TEM and EBSD. The results show that the refinement efficiency of high purity aluminum single crystal was poor in the initial stage. Extrusion by fewer ECAP passes (n ≤ 8) res...
متن کاملMicrostructure of Ultrafine- Grained Metals after Ecap
This paper was aimed at verification of functionality of the ECAP technology at extrusion of the copper, alluminium alloys and steel. Experiments were made on equipment, which is demonstrated in the Fig 1. Deformation forces were measured during extrusion, resistance to deformation was calculated and deformation speed was determined approximately. Analysis of structure was made with use of ligh...
متن کاملMechanical Properties and Microstructure Development of Ultrafine-grained Cu Processed by ECAP
Technical purity Cu (99.95 wt%) polycrystals have been processed at room temperature by equal channel angular pressing. The results of mechanical tests and the microstructure characterization by various experimental techniques are presented. The yield stress as well as the strength were shown to increase with increasing strain and exceed the respective values of a coarse-grained material. The m...
متن کاملDENSIFICATION AND MICROSTRUCTURE CHARACTERISTICS OF A PREALLOYED ALPHA BRASS POWDER PROCESSED BY LIQUID PHASE SINTERING
The rapidly solidified prealloyed alpha brass powder with a size range of 40 to 100 μm produced by water atomization process was consolidated using liquid phase sintering process. The relationships between sintering temperature, physic-mechanical properties and microstructural characteristics were investigated. Maximum densification was obtained at 930 °C, under 600 MPa compacting pressure,...
متن کاملTen years of severe plastic deformation (SPD) in Iran, part I: equal channel angular pressing (ECAP)
The superior properties of ultrafine-grained materials fabricated by severe plastic deformation (SPD) have attracted the attention of many researchers around the world. Among the top-ranked countries that are active in this field, Iran is interesting because of the late beginnings of SPD in this country and, subsequently, the highest rate of growth in the number of publications during the last...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals and Materials International
سال: 2020
ISSN: 1598-9623,2005-4149
DOI: 10.1007/s12540-020-00817-3