Microstructure Evolution and Texture Development in a Cu-8.5%AT. AL Material Subjected to Hydrostatic Extrusion
نویسندگان
چکیده
منابع مشابه
Dislocation Substructure Evolution during Hydrostatic Extrusion of Al Mg Si Alloy
Hydrostatic extrusion is a technique which allows to produce rods with ultra ne grains and unexpectedly enhanced mechanical properties caused by grain re nement. However, the mechanism of such a re nement is not fully understood at this stage. 6xxx aluminium alloys series are usually processed by extrusion. In this study, commercial 6082 aluminium alloy was extruded at ambient temperature in a ...
متن کاملTexture Development in YBa 2 Cu 30 , by Hot Extrusion and Hot - Pressing
case of 18 kN, a considerable portion of the particles are mechanically broken. The structure is condensed nearly without cavities. It might be useful to prepare pellets of high density, as the diffusion coefficient of tritium in Li,SiO, or Li4Si04 is on the order of 2 magnitudes higher than in the other lithium compounds.’ Li2Si03.nH20 is X-ray amorphous. ‘ A considerable portion of the powder...
متن کاملDevelopment of microstructure and fracture toughness of AL-6063 alloy using equal channel angular extrusion
Severe plastic deformation (SPD) is one of the processes used to refine the microstructure of materials. Equal Channel Angular Extrusion (ECAE) is the most common method of SPD. In this study, AL-6063grain refinement was performed using the Equal Channel Angular Extrusion method. The material was extruded up to 6 passes at a temperature of 200°C following route A. A suitable die sets equipped w...
متن کاملMicrostructure, Welding Mechanism, and Failure of Al/Cu Ultrasonic Welds
Ultrasonic metal welding has been used widely to join battery cell terminals, or tabs (either Al or Cu), with bus bars (Cu) to form assembled battery packs in battery electric vehicles. However, the mechanism of ultrasonic welding for Al/Cu is still not well understood. In this work, the microstructures of the ultrasonic welds between three layers of lithium-ion battery tabs (either Al or Cu) a...
متن کاملDevelopment of a strong Goss texture during annealing of a heavily rolled Al–0.3% Cu alloy
The evolution of microstructure and texture during isochronal annealing of a heavily cold rolled Al–0.3% Cu alloy has been characterized using electron backscatter diffraction. It is found that the rolling texture of this alloy is dominated by the Brass component and that recrystallization during annealing leads to the formation of a pronounced Goss texture. It is suggested that the development...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Metallurgy and Materials
سال: 2016
ISSN: 2300-1909
DOI: 10.1515/amm-2016-0158