Microstructure of Carbon Fiber and Carbon Reinforced Plastic

Dynamic Characteristics of Joined Steel and Carbon Fiber-Reinforced Plastic Tubes: Experimental and Numerical Investigation

The fundamental frequencies and mode shapes of steel and carbon fiber–reinforced plastic (CFRP) cylindrical shells with steel inserts were investigated using finite element analysis and modal testing. The free-free boundary condition was tested with modal testing using the roving hammer method and verified by finite element analysis using ABAQUS. The results show good agreement between the test...

Carbon Fiber Reinforced Bismaleimide Composites

Bismaleimide (BMI) resins are developed very rapidly due to the demands of the defense and aerospace industries. They are cross-linked polymers which process like epoxy resins but have an upper use temperature of 230°C, compared to the epoxy upper use temperature of 175°C. Also due to the available intrinsic properties of BMI resins such as higher thermal stability and lower toxicity than those...

Damage Detection of Carbon Fiber-reinforced Concrete Under Bending Test

Effect of Fiber Surface Treatment on Wear Characteristics of Carbon Fiber Reinforced Polyamide 6 Composites

Ozone modification method and air-oxidation were used for the surface treatment of polyacrylonitrile(PAN)-based carbon fiber. The surface characteristics of carbon fibers were characterized by X-ray photoelectron spectroscopy (XPS). The interfacial properties of carbon fiber reinforced polyamide 6 (CF/PA6) composites were investigated by means of the single fiber pull-out tests. As a result...

Development of a Staggered PCD End Mill for Carbon Fiber Reinforced Plastic

This work presents a PCD (polycrystalline diamond) end mill with a new staggered structure for the milling of CFRP (carbon fiber reinforced plastic). The magnitude and direction of cutting force is decreased and changed by side-edge re-configuration of the structure. The flute and insert pocket of the staggered PCD end mill are designed considering the tool’s stiffness and welding process. The ...