Milling parameters of Al-Cu and Al-Si cast alloys

Creep Behavior of Al-Si Die-Cast Alloys

Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...

Fluidized Bed Heat Treatment of Cast Al-Si-Cu-Mg Alloys

The effects of fluidized bed heat treatment on the microstructural and mechanical properties of Al-Si-Cu-Mg cast alloys, namely,3 54 and 319, were studied. The heating rate in fluidized beds (FBs) is greater vis-a`-vis conventional electrical resistancef urnaces (CFs). The high heating ratei nF Bs increases the kinetics of metallurgical phenomena such as Si fragmentation and spherodization duri...

THERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS

Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...

Precipitation Hardening of Al–Si–Mg Alloys

Elemental separation in nanocrystalline Cu-Al alloys

Y. B. Wang, X. Z. Liao, Y. H. Zhao, J. C. Cooley, Z. Horita, and Y. T. Zhu School of Aerospace, Mechanical and Mechatronic Engineering, The University of Sydney, Sydney, NSW 2006, Australia School of Materials Science and Engineering, Nanjing University of Science and Technology, Nanjing 210094, China Division of Materials Science and Technology, Los Alamos National Laboratory, Los Alamos, New ...