Minimum Diameter of Microrods Machined by Micro-electrical Discharge Machining using Self-Drilled Holes Method
نویسندگان
چکیده
منابع مشابه
Performance study of electrical discharge machining process in burr removal of drilled holes in Al 7075
Deburring is the finishing technique that is very essential for the manufacturing of precise components. Although there are various methods to remove burrs but sometimes technology requires new innovative ideas for better outcome irrespective of cost. Deburring with greater efficiency and full automation is a difficult task and this thing leads to use unconventional approaches. This research pa...
متن کاملReview on Micro Electrical Discharge Machining
Recent trend in reducing the size of products has given Micro Electrical Discharge Machining (MEDM) a significant amount of research attention. Due to the high precision, low tolerance and good surface quality that it can deliver, MEDM is potentially an important process for fabrication of micro-tools, micro-components and parts with micro-features. This paper briefs and highlights the various ...
متن کاملModeling and Simulation of Micro Electrical Discharge Machining Process
ii ACKNOWLEDGEMENTS iv TABLE OF CONTENTS v LIST OF FIGURES ix LIST OF TABLES xiii CHAPTER
متن کاملMicro Wire Electrical Discharge Machining , Main Aspects , Tools And
The increasing demand of micro or miniature parts and the development of the micro machining processes are the cause of the growing of micro wire electrical discharge machining (μ-WEDM). μ-WEDM has the ability to manufacture complicate shapes with high accuracy and provides the advantage of machining any conductive materials regardless of their mechanical properties in the absence of significan...
متن کاملReal-time depth measurement for micro-holes drilled by lasers
An optical system based on the confocal principle has been developed for real-time precision measurements of the depth of micro-holes during the laser drilling process. The capability of the measuring system is theoretically predicted by the Gaussian lens formula and experimentally validated to achieve a sensitivity of 0.5 μm. A nanosecond laser system was used to drill holes, and the hole dept...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Denki Kako Gakkaishi
سال: 2008
ISSN: 1881-0888,0387-754X
DOI: 10.2526/jseme.42.51