Minimum Water Requirement Method for High-Performance Sulphoaluminate Cement-Based Materials

The Compressive Strength of Cement–Slag–Calcium Sulphoaluminate Ternary System

At present, there is an increasing interest on the use of calcium sulphoaluminate (C4A3$) in cement. In this paper, pure mineral of sulphoaluminate (C4A3$) was prepared in laboratory. Different dosages of steel slag and C4A3$ were blended into cement. The aim of this paper is to investigate the compressive strength of this ternary system. The test results show that the addition of C4A3$ can imp...

Early-Age Properties of Cement-Based Materials: II. Influence of Water-to-Cement Ratio

The influence of water-to-cement mass ratio (w/c) on early-age properties of cementbased materials is investigated using a variety of experimental techniques. Properties that are critical to the early-age performance of these materials are tested, including heat release, semiadiabatic temperature, setting time, autogenous deformation, and strength development. Measurements of these properties u...

Piezoresistive Cement-based Materials for Strain Sensing

Cement-based materials that exhibit piezoresistivity with sufficient magnitude and reversibility contain electrically conductive fibers. The phenomenon allows the materials to sense their own strain. The fibers are preferably discontinuous. Carbon fibers (15mm diameter) are most effective. Steel fibers (8 mm diameter) are less effective. Carbon filaments (0.1 mm diameter) are ineffective. The p...

Minimum water requirement for social and economic development

There is no common understanding of the minimum per capita fresh water requirement for human health and economic and social development. Existing estimates vary between 20 and 4,654 l/c/d, however, these estimates are methodologically problematic as they consider only human consumptive and hygiene needs, or they consider economic needs but not the effects of trade. Reconsidering the components ...

1 Current Innovations in Cement - Based Materials