Mixed-Mode Delamination Failure Model of Sandwich Plate
نویسندگان
چکیده
منابع مشابه
Mixed-Mode Bending Method for Delamination Testing
A mixed—mode delamination test procedure was developed combining double cantilever beam (DCB) mode I loading and end-notch fixture (ENF) mode II loading on a split unidirectional laminate. By loading with a lever, a single applied load simultaneously produces mode I and mode II bending loads on the specimen. This mixed-mode bending (MMB) test was analyzed using both finite-element procedures an...
متن کاملRefinements to the Mixed-Mode Bending Test for Delamination Toughness
The mixed-mode bending (MMB) test for delamination toughness was first introduced in 1988. This simple test is a combination of the standard Mode I (opening) test and a Mode II (sliding) test. This MMB test has become widely used in the United States and around the world for mixed-mode toughness measurements. Because of the widespread use of this test method, it is being considered for standard...
متن کاملComprehensively simulating the mixed-mode progressive delamination in composite laminates
Gao, Zhenyuan MSAA, Purdue University, May 2015. Comprehensively Simulating the Mixed-Mode Progressive Delamination in Composite Laminates. Major Professor: Wenbin Yu. Delamination, or interlaminar debonding, is a commonly observed failure mechanism in composite laminates. It is of great significance to comprehensively simulate the mixed-mode progressive delamination in composite structures bec...
متن کامل3D Mixed-Mode Delamination Fracture Criteria–An Experimentalist’s Perspective
Many delamination failure criteria based on fracture toughness have been suggested over the past few decades, but most only covered the region containing mode I and mode II components of loading because that is where toughness data existed. With new analysis tools, more 3D analyses are being conducted that capture a mode III component of loading. This has increased the need for a fracture crite...
متن کاملDelamination analysis after carbon/epoxy plate drilling
The use of laminate composites in structures is under a considerable increase. The advantages of their use are related with a considerable weight reduction and consequent improvement of dynamic characteristics, in the case of aeronautics, automobile, railway and naval industries. Drilling is a widely used technique as it is always needed to assemble components in more complex structures. Drilli...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Boundary Field Problems and Computer Simulation
سال: 2015
ISSN: 2255-9132,2255-9124
DOI: 10.7250/bfpcs.2015.003