Mixing and mass transfer in ladle refining process.
نویسندگان
چکیده
منابع مشابه
Modeling of Inclusion Removal in Ladle Refining
Gas injection is widely used in secondary refining processes to homogenize chemical composition and temperature and to remove inclusions. It is an industrial requirement to minimize the size and concentration of inclusions in the product while minimizing production time to save energy and lessen refractory wear. Gas bubbling is effective to increase the cleanliness of steel mainly by two mechan...
متن کاملHeat and Mass Transfer in Leather Drying Process
Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. Determining drying characteristics of leather is vitally important so as to optimize the drying stage. This paper describes an analytical way for determination of the drying characteristics of leather. The model presented, is based on fundamental heat and mass tra...
متن کاملMultiphase Mass Transfer in Iron and Steel Refining Processes
In the present chapter, a computational fluid dynamics (CFD) model for multiphase flow was developed, allowing the simulation of two different processes, the desulfurization of hot metal in a ladle mechanically agitated by an impeller (KR process) and the desulfuri‐ zation of steel in a gas-agitated ladle. The model gives important information to charac‐ terize the fluid flow conditions, to def...
متن کاملheat and mass transfer in leather drying process
leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. determining drying characteristics of leather is vitally important so as to optimize the drying stage. this paper describes an analytical way for determination of the drying characteristics of leather. the model presented, is based on fundamental heat and mass transfe...
متن کاملSimulation of Stresses Induced by Heat and Mass Transfer in Drying Process of Clay-like Material
Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 1989
ISSN: 0915-1559
DOI: 10.2355/isijinternational.29.148