Model-Based Development of an Engine Control Module for a Spark Ignition Engine
نویسندگان
چکیده
منابع مشابه
Cylinder Pressure in a Spark - Ignition Engine : A Computational Model
an s-curve to describe the gradual transition between exhaust pressure and intake or inlet pressure. The start of compression, which marks the end of the intake process, does not necessarily occur at the same time as the close of the intake valve (IVC). The intake valve closes after bottom center (BC) while the volume in the cylinder is decreasing. The engine speed determines the point at which...
متن کاملAn Efficient Method for Knock Signal Denoising in Spark Ignition Engine
One of the factors that affects the efficiency and lifetime of spark ignited internal combustion engine is “knock”. Knock sensor is a commonly used to detect this phenomenon. However, noise, limits detection accuracy of this sensor. In this study, Empirical Mode Decomposition (EMD) method is introduced as a fully adaptive signal-based analysis. Then, based on weighting decomposition...
متن کاملControl Oriented Model of a Dual Equal Variable Cam Timing Spark Ignition Engine
A control oriented engine model is developed to represent a spark ignited engine equipped with a variable cam timing mechanism over a wide range of operating con ditions Based upon laboratory measurements a continuous nonlinear low frequency phenomenological engine model is developed With respect to a xed cam timing engine the VCT mechanism alters the mass air ow into the cylinders the torque r...
متن کاملNonperiodic oscillations of Pressure in a SPARK Ignition Combustion Engine
We report our results on non-periodic experimental time series of pressure in a spark ignition engine. The experiments were performed for a low rotational velocity of a crankshaft and a relatively large spark advance angle. We show that the combustion process has many chaotic features. Surprisingly, the reconstructed attractor has a characteristic butterfly shape similar to a chaotic attractor ...
متن کاملSpark Ignition Engine Fuel-to-Air Ratio Control: An Adaptive Control Approach
This paper presents the control of Spark Ignition (SI) Internal Combustion (IC) engine Fuel-to-Air Ratio (FAR) using an adaptive control method of time-delay systems. The objective is to maintain the in-cylinder FAR at a prescribed set point, determined primarily by the state of the Three-Way Catalyst (TWC), so that the pollutants in the exhaust are removed with the highest efficiency. The FAR ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2018
ISSN: 2169-3536
DOI: 10.1109/access.2018.2870061