Modeling and Analysis of Thermal Flexure Actuator Using COMSOL Multiphysics
نویسندگان
چکیده
منابع مشابه
Modeling Microfluidic Separations using Comsol Multiphysics
Infrared spectroscopy can be used to identify and quantify individual (bio)chemical species within complex mixtures provided the spectroscopic fingerprints are strong enough. It is often the case, however, that the characteristic fingerprints are concealed by the much stronger absorptions of the most concentrated species. For example, in the case of blood serum, the very strong absorptions of p...
متن کاملTwo-Dimensional PEM Fuel Cells Modeling using COMSOL Multiphysics
A fuel cell has been considered as an efficient and clean alternative power source for automobile industry since the energy crisis forced people to find a substitution for fossil fuels. A proton exchange membrane fuel cell, also known as polymer electrolyte membrane fuel cell (PEMFC), becomes a prime candidate for applications in vehicles because of its following features: the PEMFC operates at...
متن کاملSensitivity Analysis of MEMS Based Piezoresistive Sensor Using COMSOL Multiphysics
The present paper peruses MEMS based piezoresistive pressure sensor and its fabrication techniques. Simulation of the pressure sensor is done by using COMSOL Multiphysics software for P-type silicon piezoresistor. The deflection of N-type silicon diaphragm depends upon the Young’s modulus of the material and varies with the amount of force applied to the diaphragm. The simulation result emphasi...
متن کاملNormal Mode Analysis of the Chesapeake Bay Using COMSOL Multiphysics
A Normal Mode Analysis (NMA) of the Chesapeake Bay was performed using Neumann boundary conditions and COMSOL MultiPhysics (formerly known as FEMLAB). The lowest 100 eigenstates were calculated and compared to a finite difference solution. Based on the normal modes derived numerically, surface current vector fields can be calculated. The vector fields of the Chesapeake Bay provide tools for the...
متن کاملEffective Modeling and Simulation of Engineering Problems with COMSOL Multiphysics
Mastery of finite element theory is necessary to write finite element program, but it is not necessary to use COMSOL Multiphysics package. It is only necessary to understand the physical problem at hand, how to use the finite element program, and how to interpret the results. This paper gives an introduction to modeling in COMSOL Multiphysics, as being employed in the course heat transfer, by d...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Computer and Electrical Engineering
سال: 2014
ISSN: 1793-8163
DOI: 10.7763/ijcee.2014.v6.841