Modeling and Design of Split-Pi Converter
نویسندگان
چکیده
High-power bidirectional dc–dc converters are being widely employed in renewable energy interfacing, storage, electric vehicle charging, military, aerospace, and marine applications. Among various topologies documented the literature for power conversion, split-pi converter invites special attention with regard to applications involving multi-phase systems requiring high-power density. This paper endeavors present small-signal modeling of its operating modes. Subsequently, dynamic characteristics studied, appropriate control design is presented stable operation converter. Frequency response plots illustrated, a hardware prototype model designed implemented.
منابع مشابه
Hybrid Z-Source DC-DC Converter with ZVZCS and Power Transformer Resetting: Design, Modeling, and Fabrication
This paper introduces a novel two transistors forward topology employing a z-source to achieve ZVZCS and power transformer resetting for various applications. Comparing with the forward converter, this topology has the advantage of displaying ZCS condition with an added Z-Source and no additional switches when the switches turn on, and that ZVS condition happens when the switches turn off. Duty...
متن کاملDesign and Simulation of a PI Controlled Soft Switched Front End Converter for Switched Reluctance Motor
This paper presents the design, and simulation of a soft switched boost converter for a switched reluctance motor with a closed loop controller. A soft switching scheme is proposed in the converter with minimum components, which reduces the switching loss and stress across the switch so that the harmonic generation is reduced in the output. The switch used in this converter switched ON at zero ...
متن کاملDesign and Implementation of Gain Scheduling PI-Controller for DC-DC Boost Converter Control System
This paper provides design and implementation of a DC-DC boost converter control system by using gain scheduling PI-controller to achieve stable regulated output voltage with improved dynamic performance. The proposed controller parameters are obtained from system output response based on step input signal. A test step input is applied to the system and the three parameters of the plant are obt...
متن کاملDesign and Analysis of PI like Fuzzy Logic Controlled Buck Converter
This paper presents a novel design of Proportional and Integral (PI) like Fuzzy Logic Controller (FLC) for Buck converters that integrates linear control techniques with Fuzzy Logic .The design procedure allows the small signal model of the converter and linear control design techniques to be used in the initial stages of FLC design. This simplifies the small signal design and stability assessm...
متن کاملBurst Mode Switched Capacitor Voltage Converter Modeling and Design
An inductorless switched capacitor (SC) DC-DC voltage converter and a model based on the averaging technique are presented. The model was validated through circuit level simulations for a SC converter designed using CMOS 0.18 um technology, capable to deliver output currents up to 100 mA at a regulated low ripple 3.3 V output voltage, for input voltages between 1.8 V and 3.2 V and can be used f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energies
سال: 2022
ISSN: ['1996-1073']
DOI: https://doi.org/10.3390/en15155690