Modeling gas transfer in a spray tower oxygen absorber
نویسندگان
چکیده
منابع مشابه
Dynamics of wet flue gas desulphurization in spray absorber
A concise one dimensional thermal-hydraulic two-fluid model is presented for the numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the water-limestone slurry in the vertical spray tower absorber. The model is based on mass, momentum and energy balance equations for each phase separately, i.e. downward falling droplets of water-limestone slurry and upward flowing...
متن کاملSeawater So2 Scrubbing in a Spray Tower for Marine Application
A seawater spray scrubber was set up and tested with focus on desulfurization of marine engine exhaust gas. Experimental tests were carried out simulating typical exhaust conditions of a marine diesel engine burning heavy fuel oil, and using real seawater. Different flue gas flow rates, seawater flow rates, and SO2 concentrations were tested. Liquid-to-gas ratios were in the range 1-10 x 10. A ...
متن کاملRemoval of air ammonia in a spray tower by dilute sulfuric acid solution
Introduction: Workplace air quality is a very important factor in community health and is measured by measuring and evaluating airborne contaminants. One of these airborne pollutants is ammonia gas. Spray towers are important components of air pollution control. The aim of this study was to investigate the effects of using diluted sulfuric acid solution on the efficiency of ammonia removal in a...
متن کاملExperimental Study of Chemical Absorption of CO2 in a Bench-Scale Spray Dryer Absorber
The removal of CO2 through chemical absorption in a bench-scale spray dryer absorber was investigated experimentally using the lime slurry as absorbent. The effect of important operating parameters on CO2 removal efficiency has been investigated; in selected ranges of operating parameters, increasing gas inlet temperature and absorbent concentration lead to permanent efficiency decline, increas...
متن کاملModeling oxygen transport in surgical tissue transfer.
Reconstructive microsurgery is a clinical technique used to transfer large amounts of a patient's tissue from one location used to another in order to restore physical deformities caused by trauma, tumors, or congenital abnormalities. The trend in this field is to transfer tissue using increasingly smaller blood vessels, which decreases problems associated with tissue harvest but increases the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Aquacultural Engineering
سال: 1997
ISSN: 0144-8609
DOI: 10.1016/s0144-8609(96)01011-4