Modeling Mixer and Power Amplifier Impairments
نویسندگان
چکیده
منابع مشابه
Power Amplifier Modeling and Power Amplifier Predistortion in Ofdm System
This paper presents a baseband predistorter to be used in OFDM systems operating with a nonlinear high power amplifier (HPA). Key features of the predistorter reside in the use of the HPA inverse structure as nonlinear distortion compensator. The performance of the compensated system is analyzed by simulations in an AWGN environment. The receiver also needs furthermore an equalizer in order to ...
متن کاملMemoryless Non Linear Modeling of Power Amplifier
To ensure that linearity is maintained to a high degree, it is necessary to examine the nature of amplifier distortion. Audio amplifier distortion is of concern for many years. The conventional feedback techniques used at audio frequencies are not applicable to many RF amplifiers due to following problems: 1. Stability at high bandwidth; 2. Cost for high gains in RF stages. Memory less or Insta...
متن کاملBehavioral modeling and linearization of a millimeter-wave power amplifier
The use of digital predistortion for linearizing a millimeter-wave power amplifier (PA) is investigated. A PA operating at 38 GHz is designed using an accurate non-quasi-static transistor model, taking into account both shortand long-term memory effects. A realistic test signal is then used for the identification of a nonlinear auto-regressive moving average (NARMA) behavioral model of the PA. ...
متن کاملCmos Power Device Modeling and Amplifier Circuits By
A power amplifier (PA) is a key part of the RF front-end in transmitters for a local broadband network. Today, commercial PAs are made of III-V HEMT and HBT technology with excellent results. An integrated system-on-chip power amplifier circuit using CMOS technology for cost-effective and spectrum-efficient high-speed wireless communication presents major challenges because power amplifiers hav...
متن کاملModeling of Power Amplifier Distortion in MIMO Trans- mitters
Facing an always growing need for higher data rate, telecommunications operators cannot rely on a bandwidth increase any more as the frequency spectrum in the UHF band is nowadays crowded. Therefore new technologies need to be developed to boost the data rate. Among those, multiple inputs multiple outputs systems (MIMO) provide both a significant rise in bit rate and a better reliability for th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Microwave and Wireless Components Letters
سال: 2019
ISSN: 1531-1309,1558-1764
DOI: 10.1109/lmwc.2019.2915647