Modeling of thermal and lattice misfit stresses within a thermal barrier coating
نویسندگان
چکیده
منابع مشابه
Thermal Conductivity of a Zirconia Thermal Barrier Coating
The conductivity of a thermal-barrier coating composed of atmospheric plasma sprayed 8 mass percent yttria partially stabilized zirconia has been measured. This coating was sprayed on a substrate of 410 stainless steel. An absolute, steady-state measurement method was used to measure thermal conductivity from 400 to 800 K. The thermal conductivity of the coating is 0.62 W/(m⋅K). This measuremen...
متن کاملEvaluation of thermal conduction anisotropy on Thermal Barrier Coating
The microstructural analysis of Thermal Barrier Coatings, deposited according to the Air Plasma Spray technology, furnishes information according which a strong orthotropic thermal conductivity is expected to be measured for such a material. Pulsed experiment with a localized heating source and thermographic temperature recording, permit to evaluate both the in-depth and in-plane components of ...
متن کاملA review of thermal barrier coating effects on diesel engine performance and components lifetime
In the present paper, a complete literatures review of thermal barrier coating applications in diesel engines is performed to select a proper type and to find coating effects. The coating system has effects on the fuel consumption, the power and the combustion efficiency, pollution contents and the fatigue lifetime of engine components. Usually there are several beneficial influences by appl...
متن کاملCrack propagation in thermal barrier coating systems
Thermal barrier coating systems are used on top of highly stressed components in gas turbines to protect the nickel-based substrates. A well-established thermal barrier coating system consist of the bond-coat (BC) and the thermal barrier coating (TBC). A third layer is grown during service: the thermally grown oxide (TGO) between the BC and the TBC. The coatings fail in service because of diffe...
متن کاملSimulation of stresses and delamination in a plasma-sprayed thermal barrier system upon thermal cycling
A thermal barrier system with plasma-sprayed thermal barrier coating (TBC) has been analyzed subject to thermal cycling. The thermally grown oxide (TGO) is allowed to grow at the peak temperature in the cycle, with both thickening and lateral components of the growth strain. The stresses in the TGO are also allowed to relax at high temperature when they attain a critical level. The bond coat is...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanics of Materials
سال: 2018
ISSN: 0167-6636
DOI: 10.1016/j.mechmat.2018.03.009