Modelling and Optimization for Heat Treatment of Al-Si-Mg Alloy Prepared by Indirect Squeeze Casting Based on Response Surface Methodology
نویسندگان
چکیده
منابع مشابه
Optimization of Centrifugal Casting Parameters of AlSi Alloy by using the Response Surface Methodology
Centrifugal casting is one of the advanced casting branches widely used in the metallurgical industry in which the centrifugal force helps strengthen the workpiece material. The present work attempt to study the effect of the horizontal and vertical centrifugal casting parameters included the centrifugal mold rotation speeds and G-factors values on the quality of the product. The work has been ...
متن کاملOptimization of US-Electropersulfate Process for Leachate Treatment by Response Surface Methodology
Introduction: Chemical Oxidation Demand (COD) is an important parameter in treatment of leachate. Leachate from solid waste has a high pollutants that must be treatment before discharge to environment. The aim of this study was optimization of US-Electro/persulfate process, predicate of optimum conditions by RSM for landfill leachate treatment. Methods and materials: In this experimental st...
متن کاملLocalized Recrystallization in Cast Al-Si-Mg Alloy During Solution Heat Treatment: Dilatometric and Calorimetric Studies
During heat treatment, the work piece experiences a range of heating rates depending upon the sizes and types of furnace. When the Al-Si-Mg cast alloy is heated to the solutionizing temperature , recrystallization takes place during the ramp-up stage. The effect of heating rate on recrystallization in the A356 (Al-Si-Mg) alloy was studied using dilatometric and calorimetric methods. Recrystalli...
متن کاملOptimization and Modeling of CuOx/OMWNT’s for Catalytic Reduction of Nitrogen Oxides by Response Surface Methodology
A series of copper oxide (CuOx) catalysts supported by oxidized multi-walled carbon nanotubes (OMWNT’s) were prepared by the wet impregnation method for the low temperature (200 °C) selective catalytic reduction of nitrogen oxides (NOx) using NH3 as a reductant agent in the presence of excess oxygen. These catalysts were characterized by FTIR, XRD, SEM-EDS, and H2-TPR meth...
متن کاملpreparation and characterization of new co-fe and fe-mn nano catalysts using resol phenolic resin and response surface methodology study for fischer-tropsch synthesis
کاتالیزورهای co-fe-resol/sio2و fe-mn-resol/sio2 با استفاده از روش ساده و ارزان قیمت همرسوبی تهیه شدند. از رزین پلیمری resol در فرآیند تهیه کاتالیزور استفاده شد.
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2017
ISSN: 1980-5373,1516-1439
DOI: 10.1590/1980-5373-mr-2017-0300