Modelling of WEDM Parameters Using Taguchi & Fuzzy Logic
نویسندگان
چکیده
منابع مشابه
Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method
Wire electrical discharge machining (WEDM) is extensively used in machining of conductive materials when precision is of prime importance. Rough cutting operation in WEDM is treated as a challenging one because improvement of more than one machining performance measures viz. metal removal rate (MRR), surface finish (SF) and cutting width (kerf) are sought to obtain a precision work. Using Taguc...
متن کاملOptimization of WEDM Process Parameters on Titanium Alloy Using Taguchi Method
This paper describes an optimum cutting parameters for Titanium Grade5 (Ti-6Al-4V) using Wire-cut Electrical Machining Process (WEDM). The response of Volume Material Removal Rate (MRR) and Surface Roughness (Ra) are considered for improving the machining efficiency. A brass wire of 0.25mm diameter was applied as tool electrode to cut the specimen. The Experimentation has been done by using Tag...
متن کاملParametric Study of Dry WEDM Using Taguchi Method
Wire Electrical Discharge Machining (WEDM) is a non-traditional thermo-electric process capable of machining hard materials of highly complex three dimensional shapes. In this paper, the dry WEDM experimentation is conducted using oxygen as a dielectric medium. The deionized water is replaced by the oxygen as a dielectric medium to ameliorate the environmental impact in the machining surroundin...
متن کاملOptimization of Process Parameters of Wire Electrical Discharge Machining Using Fuzzy logic Integrated with Taguchi Method
In this paper, fuzzy logic integrated with the Taguchi method is used to optimize Wire Electro Discharge Machining (WEDM) process with multiple quality characteristics. Rough machining with EDM gives poor surface finish and has micro cracks and pores. Finish machining gives better surface finish but with very poor machining speed (MRR). Spark gap width is one of the important performance measur...
متن کاملOptimization of process parameters of cryogenic treated D-3 in WEDM by Taguchi Approach
Cryogenic treated high carbon high chromium alloy cold tool steels (D-3) are used in production of high performance dies, punches, blanking and punching tools, extrusion tools, etc. cryogenic treatment is a process of keeping the specimen in cold environment to increase its wear resistance and relieving its residual stresses. Due to its high hardness Wire Electric Discharge Machine (WEDM) seems...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-899X
DOI: 10.1088/1757-899x/1017/1/012001