Modification of Al-11% Si Alloy with Cl - Based Modifier
نویسندگان
چکیده
منابع مشابه
Modification of Primary Si Crystals and Fe-rich Intermetallics in LM28 Al Alloy Fabricated Through Thixoforming
In the present research, thixoforming route was carried out in order to enhance the microstructural features of LM28 piston alloy. Typical microstructure of this alloy was composed of coarse, polygonal primary silicon particles, eutectic matrix and intermetallic phases. Thermal analysis was carried out to study the solidification path of the base alloy and determine the major arrest temperature...
متن کاملModification of Al - Si Alloy ( LM 28 ) By MnO 2 Addition
Modification of primary silicon was studied in Al-Si hypereutectic alloys with 17 Wt % silicon content. The alloys modified through non-conventional method using oxide addition. The effect of oxide on the morphology and size of Si phases in the hypereutectic Al-Si alloys investigated. The results show that the addition of MnO2 to the hypereutectic Al-Si alloys can modify the primary Si phases. ...
متن کاملEffect of Al–5Ti–C Master Alloy on the Microstructure and Mechanical Properties of Hypereutectic Al–20%Si Alloy
Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...
متن کاملAn Overview of the Development of Al-Si-Alloy Based Material for Engine Applications
The development of Al-Si alloy and its based material for engine application is reported in this paper, focusing on improving the material’s fatigue limit and wear resistance, which are two important properties for engine block materials. The paper begins with a description of the microstructure (primary and eutectic phases, intermetallics, and casting defects) of Al-Si alloy and its effects on...
متن کاملTHE INFLUENCE OF DRY SLIDING ON PRCIPITATION HARDENING BEHAVIORS OF Al-Cu-Si ALLOY
Abstract: Cold working performed before an aging treatment has a significant effect on size and amount of precipitate produced. This could be caused by the increase in defect density, such as vacancies and dislocations. In this research, the Al-Cu-Si alloy was solution-treated, wear-tested and then artificially aged for a period of 1–5 h. Changes in the amount of precipitate, in the lattice par...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2015
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2015/a/1213-2489/mt/15/4/581