Mold Filling and Solidification during Centrifugal Precision Casting of Ti–6Al–4V Alloy
نویسندگان
چکیده
منابع مشابه
Solidification and Particle Entrapment during Continuous Casting of Steel
Avoiding particle entrapment into the solidifying shell of a steel continuous caster is important to improve the quality of the continuous cast product. Therefore, the fluid flow dynamics in the steel melt and mushy zone, heat transfer and solidification of the steel shell, as well as the motion and entrapment of inclusion particles during the casting process were investigated using computation...
متن کاملOptimization of Centrifugal Casting Parameters of AlSi Alloy by using the Response Surface Methodology
Centrifugal casting is one of the advanced casting branches widely used in the metallurgical industry in which the centrifugal force helps strengthen the workpiece material. The present work attempt to study the effect of the horizontal and vertical centrifugal casting parameters included the centrifugal mold rotation speeds and G-factors values on the quality of the product. The work has been ...
متن کاملSolidification and thermal performance analysis of the low carbon steel during the continuous casting process
The present paper evaluates the effect of the nozzle characteristics on the heat transfer and phase change of the low carbon steel during the continuous casting process. A three-dimensional energy equation and a solidification model are used to drive the governing equation of the phase change and temperature distribution. A linear relation is obtained to predict the temperature-dependent of the...
متن کاملModeling of Solidification of Mmc Composites during Gravity Casting Process
R. Zagórski, S. Golak – Silesian University of Technical, Department of Management and Computer Science, Katowice, Poland The paper deals with computer simulation of gravity casting of the metal matrix composites reinforced with ceramics (MMC) into sand mold . The subject of our int erest is aluminum matrix c omposite (AlMMC) reinforced with c eramic particles i.e. silicon carbide SiC and glass...
متن کاملThe Effect of Dewaxing and Burnout Temperature in Block Mold Process for Copper Alloy Casting
The main objective of this research is to investigate the effect of dewaxing and burnout temperature on the quality of copper alloy casting produced by a low cost block mold that has been developed. In the molding process, two types of silica sand which contains 97.9% silica (SiO2) and 97.2% silica have been used as a refractory material with POP served as a binder. Several mold formulations co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Transactions, JIM
سال: 1996
ISSN: 0916-1821,2432-471X
DOI: 10.2320/matertrans1989.37.1793