Mold Surface Analysis after Injection Molding of Highly Filled Polymeric Compounds
نویسندگان
چکیده
منابع مشابه
Effects of Mold Surface Roughness on Compressible Flow of Micro-Injection Molding
be obtained as [5] Thus, the vol a surface roughness is δ=3S . ume fraction can he effective roughness height (δ) in terms of the average T to represent the physical surface roughness of the homogeneous pyramid roughness profile he equivalent three surface roughness. T -dimensional as the parameter to characterize the surface profilometer, , which can be measured easily using 3D a average...
متن کاملAnalysis of the Three Dimensional Mold-filling Process in Injection Molding
For the three decades, the mold-filling of injection molding process was modeled as Hele-Shaw model. However, this model can not consider the 3D effect. In this paper, numerical simulations of three dimensional mold-filling during the filling phase were performed. The governing equations were discretized by segregated finite element method, which used equal order interpolation for pressure and ...
متن کاملImplementation and analysis of polymeric microstructure replication by micro injection molding
This paper presents the adaptation of a conventional injection molding process to the mass replication of polymeric microstructures with appropriate mold design and process control. Using wet-etched silicon wafers with microstructures on the surfaces as mold inserts, we have successfully predicted, improved and optimized the replication results. The flow behaviors of polymer melts in micro mold...
متن کاملStability analysis of injection molding flows
We numerically investigate the stability problem of the injection molding process. It was indicated by Bulters and Schepens Bulters and Schepens 2000 that surface defects of injection molded products may be attributed to a flow instability near the free surface during the filling stage of the mold. We examine the stability of this flow using the extended Pom–Pom constitutive equations. The mode...
متن کاملInfluence of Temperature and Polymer/ Mold Surface Interactions on Micro-feature Replication at Ambient Pressure in Micro Injection Molding
Microinjection molding is based on the concept of vario-thermal processing in which the injection unit heats the polymer and presses it into a micro featured mold. After the unit cools, the featured part is de-molded. An inherent problem with microinjection molding is poor feature replication. The polymer in the micro-cavity instantaneously freezes when it comes in contact with the mold wall th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2016
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2016/a/1213-2489/mt/16/1/86