MOLDING SAND RESEARCH
نویسندگان
چکیده
منابع مشابه
The Inherited Traditional Culture of Automobile Molding DNA Design Research
Design of automobile modeling DNA is the core that makes enterprises establishes a good and unique brand image to win on market. This paper described the definition and meaning of production DNA, also discussed the composition of production DNA and researched the design ideas of production DNA from both macro and micro aspects. Finally, it recommended would research the traditional culture into...
متن کاملDevelopment of an Intelligent Cavity Layout Design System for Injection Molding Dies (RESEARCH NOTE)
This paper presents the development of an Intelligent Cavity Layout Design System (ICLDS) for multiple cavity injection moulds. The system is intended to assist mould designers in cavity layout design at concept design stage. The complexities and principles of cavity layout design as well as various dependencies in injection mould design are introduced. The knowledge in cavity layout design is ...
متن کاملIntercomparison of research and practical sand transport models
A series of model intercomparisons, and model comparisons with field data, was carried out as part of the EU MASTIII SEDMOC Project (1998–2001). Initially, seven ‘research’ models were intercompared over a wide range of wave and current conditions, corresponding to both plane and rippled sand beds. These models included both one-dimensional vertical (1DV) formulations, varying in complexity fro...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science
سال: 1921
ISSN: 0036-8075,1095-9203
DOI: 10.1126/science.54.1406.570