Molecular Orientation in Injection-Molded Disk Records
نویسندگان
چکیده
منابع مشابه
Fiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملInjection molded microfluidic chips featuring integrated interconnects.
An injection molding process for the fabrication of disposable plastic microfluidic chips with a cycle time of 2 min has been designed, developed, and implemented. Of the sixteen commercially available grades of cyclo-olefin copolymer (COC) that were screened for autofluorescence and transparency to ultraviolet (UV) light, Topas 8007 x 10 was identified as the most suitable for production. A ro...
متن کاملStudy on Effects of Molded Conditions on the Fiber Orientation and Electrical Conductivity of Injection Molded Bipolar Plate for Fuel Cell
Fuel cells constitute one of the most promising sources of clean energy for the 21 century and bipolar plate is an important component of a PEM fuel cell. Polymers filled with conducting fibers have been chosen as a candidate material for bipolar plates which needs to fulfill the surface conductivity requirement. In the present paper, effect of processing parameters including melt temperature, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Kobunshi Kagaku
سال: 1971
ISSN: 1884-8079,0023-2556
DOI: 10.1295/koron1944.28.878