Molten Salt Membrane Process for Chlorine Recovery
نویسندگان
چکیده
منابع مشابه
Novel waste printed circuit board recycling process with molten salt
The objective of the method was to prove the concept of a novel waste PCBs recycling process which uses inert, stable molten salts as the direct heat transfer fluid and, simultaneously, uses this molten salt to separate the metal products in either liquid (solder, zinc, tin, lead, etc.) or solid (copper, gold, steel, palladium, etc.) form at the operating temperatures of 450-470 °C. The PCB rec...
متن کاملMolten-salt Reactor Chemistry
This document summarizes the large program of chemical research and development which led to selection of fuel and coolant compositions for the Molten-Salt Reactor Experiment (MSRE) and for subsequent reactors of this type. Chemical behavior of the LiF-BeFrZrFrUF4 fuel mixture and behavior of fission products during power operation of MSRE are presented. A discussion of the chemical reactions w...
متن کاملThe Molten Salt Reactor Adventure
A personal history of the development of molten-salt reactors in the United States is presented. The initial goal was an aircraft propulsion reactor, and a molten fluoride-fueled Aircraft Reactor Experiment was operated at Oak Ridge National Laboratory in 1954. In 1956, the objective shifted to civilian nuclear power, and reactor concepts were developed using a circulating UF4-ThF4 fuel, graphi...
متن کاملMembrane Distillation for Water Recovery and Its Fouling Phenomena
The total volume of water on Earth is circa 300 million cubic miles, with close to 98.0% being salt water and the remaining 2.0% fresh water. It has been increasingly more challenging to harvest fresh water from surface water, seawater and even from wastewater due to the combination of factors, viz. burgeoning population growth, rapid industrialization and climate change. Recently, membrane dis...
متن کاملInherent structure of a molten salt
We calculated the inherent structure of a model melt of zinc ~II! bromide over a wide range of densities. Stable, metastable, and unstable branches were obtained for the zero temperature pressure–volume isotherm of the inherent structure. The pressure–volume isotherm, the void distribution, and the structure factor were used to identify the spinodal, independent of any model equation of state. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 1999
ISSN: 0161-6374,2576-1579
DOI: 10.1149/199941.0675pv