Mössbauer studies of melt-spun Nd-Fe-Ti-Mo-N alloy
نویسندگان
چکیده
منابع مشابه
Gradient Distribution of Martensite Phase in Melt-Spun Ribbons of a Fe-Ni-Ti-Al Alloy
Metallographic, X-ray diffraction and magnetometric analysis were used to study the regularities of martensitic transformation in melt-spun ribbons of a Fe - 28 wt. % Ni - 2.1 wt. % Ti - 2 wt. % Al - 0.05 wt. % C alloy. The substantial differences in volume fractions of the martensite phase in local regions of thin melt-spun ribbons of the alloy are related to the size effect of the transformat...
متن کاملA Mössbauer spectroscopy and neutron diffraction study of magnetostrictive, melt-spun Fe-Ga alloy ribbons
Ribbons of Fe100−xGax (x = 15, 17.5, 19.5 and 22.5) were prepared by rapid solidification from the melt. Fe Mössbauer spectroscopy and high resolution neutron diffraction have revealed that Fe100xGax alloys with x = 15 and 17.5 have the disordered bcc (A2) structure even after annealing, but the alloy with x = 19.5 developed the short-range ordered D03 phase when annealed. The x = 22.5 alloys s...
متن کاملMagnetic properties and synthesis conditions of Nd2Fe23B3 melt-spun alloy
The formation of amorphous and crystalline state of the Nd2Fe23B3 alloy from melt-spun ribbon is presented. The synthesis conditions are investigated combining DSC, X-ray diffraction and thermomagnetic analysis. The thermomagnetic analysis is found to be very useful to optimize the synthesis process. Comparison of these results enables to discuss the thermal stability of both the amorphous and ...
متن کاملDirectional annealing-induced texture in melt-spun (Sm12Co88)99Nb1 alloy
Developing texture in nanocrystalline permanent magnet alloys is of significant importance. Directional annealing is shown to produce texture in the permanent magnet alloy (Sm12Co88)99Nb1. Melt spinning produced isotropic grain structures of the hard magnetic metastable SmCo7 phase, with grain sizes of ∼300 nm. Conventional annealing of melt-spun (Sm12Co88)99Nb1 alloy produced Sm2Co17 phase wit...
متن کاملPseudo-elastic deformation behavior in a Ti/Mo-based alloy
It is shown that the pseudo-elastic response in a series of Ti–Mo–V–Nb–Al alloys with 8–11 wt.% Mo is highly sensitive to both composition and heat treatment. Recovery of up to 3.0% strain has been observed but it appears that this may not be due to reversible formation of a00 martensite. 2003 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1999
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.23.294