MOULD FLOW AND STRUCTURAL ANALYSIS OF INJECTION MOULD TOOL FOR HOOTER BODY COVER COMPONENT
نویسندگان
چکیده
منابع مشابه
Automated Vision Inspection System for a Plastic Injection Mould Component
This paper presents an automated vision based defect inspection and sorting system for a plastic injection mould component called a Retractor Retaining Bush, which is an automotive safety critical component. The system identifies defects which usually occur in a plastic injection mould component. Various types of sensors and actuators were interfaced with the vision hardware and the part handli...
متن کاملExperimental model of mould filling flow
The aim of our analysis is to provide a simple experimental model simulating the main flow characteristics accompanying casting processes. Hence, a hot liquid is provided under high pressure into an inclined box. The liquid propagates inside the box between two cold isothermal walls, passing obstacles simulating internal complexity of a mould. The main features of the experiment like flow accel...
متن کاملAnalyzing the Failure of Master Mould in Casting of Copper Anode Moulds and Suggesting a more Suitable Metal Mould
Master moulds are used to cast copper anode moulds. These iron moulds are made of grey or nodular cast irons. According to desirable properties of ductile irons, it was expected that ductile cast iron ...
متن کاملTraditional mould analysis compared to a DNA-based method of mould analysis.
Traditional environmental mould analysis is based on microscopic observations and counting of mould structures collected from the air on a sticky surface or culturing of moulds on growth media for identification and quantification. These approaches have significant limitations. A DNA-based method of mould analysis called mould specific quantitative PCR (MSQPCR) was created for more than 100 mou...
متن کاملProductivity and Accuracy in Plastic Injection Mould Quotation
The quotation in the field of injection mould tool manufacturing is still so difficult mission and means so great challenge that leads the manufacturers be more bottleneck providing huge differences between the results of cost and time calculation following hand-rules or experiments. The simple cause of this is the very fact they must estimate the mould’s design and manufacturing time and cost ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2015
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2015.0405044