Mullite Powders Produced by Heterogeneous Nucleation
نویسندگان
چکیده
منابع مشابه
Nanocomposite mullite/mullite powders by spray pyrolysis
A mullite/mullite nanocomposite powder has been synthesized, composed of nanometer-size 3Al2O3 · 2SiO2 (‘3 : 2’) mullite precipitates within a matrix of the high alumina 2Al2O3 · SiO2 (‘2 : 1’) mullite. Historically, the transition from the metastable high-alumina phase to the thermodynamically stable ‘3 : 2’ phase of mullite has been thought to be a continuous process, involving a continuous s...
متن کاملMullite and Mullite/ZrO2-7wt.%Y2O3 Powders for Thermal Spraying of Environmental Barrier Coatings
Mullite and mullite/ZrO2-7wt.%Y2O3 coatings could be thought among the main protective layers for environment barrier coatings (EBCs) to protect Si-based substrates in future gas turbine engines. Considering that feedstock of the compound powder is not commercially available, two powder processing routes Spray Drying (SD) and Flame Spheroidization (FS) were implemented for both types of powders...
متن کاملNucleation mechanisms in chemically vapor-deposited mullite coatings on SiC
Dense, uniform, and adherent chemically vapor-deposited mullite coatings were deposited on SiC substrates using the AlCl3–SiCl4–H2–CO2 system. Typical coating morphology consisted of a thin interfacial layer of g–Al2O3 nanocrystallites embedded within a vitreous SiO2-based matrix. When a critical Al/Si ratio of 3.2 ± 0.29 was reached within this nanocrystalline layer, mullite crystals nucleated...
متن کاملAvailability Analysis For Heterogeneous Nucleation In A Uniform Electric Field
Industrial demands for more compact heat exchangers are a motivation to find new technology features. Electrohydrodynamics (EHD) is introduced as a promising phenomenon for heat transfer enhancement mechanisms. Similar to any new technology, EHD has not been understood completely yet and requires more fundamental studies. In boiling phase change phenomena, nucleation is the dominant mechanism i...
متن کاملTitanium foams produced by solid-state replication of NaCl powders
Open-celled titanium foams were fabricated by vacuum hot pressing of a blend of Ti and NaCl powders followed by NaCl removal in water. Densification kinetics of the Ti/NaCl blends are measured at 780 ◦C at various pressures (30–50MPa), NaCl volume fractions (30–70%) and NaCl powder sizes (50–500 m). As compared to pure Ti powders, densification kinetics of the blends is faster for relative dens...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MRS Bulletin
سال: 2004
ISSN: 0883-7694,1938-1425
DOI: 10.1557/mrs2004.113