Multi-Objective Optimization of Process Parameters in Milling of 17-4 PH Stainless Steel using Taguchi-based Gray Relational Analysis
نویسندگان
چکیده
منابع مشابه
Using Gray Relational Analysis and Taguchi Technique in Solving Multi-objective Problems for Turning Operation of Austenitic Stainless Steel
In this study, the application of gray relational analysis (GRA) and Taguchi method in multi-criteria process parameters selection of turning operation has been investigated. The process responses under study are material removal rate (MRR) and surface roughness (SR); in turn, the input parameters include cutting speed, feed rate, depth of cut and nose radius of the cutting tool. The proposed a...
متن کاملusing gray relational analysis and taguchi technique in solving multi-objective problems for turning operation of austenitic stainless steel
in this study, the application of gray relational analysis (gra) and taguchi method in multi-criteria process parameters selection of turning operation has been investigated. the process responses under study are material removal rate (mrr) and surface roughness (sr); in turn, the input parameters include cutting speed, feed rate, depth of cut and nose radius of the cutting tool. the proposed a...
متن کاملMulti-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملMulti-objective optimization in Turning of EN31 steel using Taguchi based grey relational analysis
Machining can be outlined as the process of taking away material from a work piece in the grade of chips. During a machining process, isolated of the energy is turned into heat energy through the detritions yielded between the tool and the work piece and the plastic deformation of the work material in the machining zone. Turning is charmed by several constituents, for example, the cutting speed...
متن کاملTowards sustainable machining of 17-4 PH stainless steel using hybrid MQL-hot turning process
The use of a minimum quantity of lubrication (MQL) with extremely low consumption of lubricant in machining processes has been reported as a technologically and environmentally feasible alternative to conventional flood cooling. In hot machining, the external heat source is applied during machining that will assist to increase machining performance. Many external heating techniques are availabl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineered science
سال: 2023
ISSN: ['2576-988X', '2576-9898']
DOI: https://doi.org/10.30919/es961