MULTI RESPONSE OPTIMIZATION OF EDM PROCESS PARAMETERS FOR INCONEL X-750 USING MOORA

Optimization of Process Parameters in Wire Electrical Discharge Machining of Inconel X-750 for Dimensional Deviation Using Taguchi Technique

Optimization of EDM Process Parameters: A Review

Electrical Discharge Machining performance is generally evaluated on the basis of Material Removal Rate (MRR), Tool Wear Rate (TWR), Relative Wear Ratio (RWR) and Surface Roughness (SR). The important EDM machining parameters affecting to the performance measures of the process are discharge current, pulse on time, pulse off time, arc gap, and duty cycle [9]. A considerable amount of work has b...

Optimization of Edm Process Parameters Using Taguchi Method: a Review

Electrical discharge machining is assessed on the basis of Material Removal Rate (MRR), Tool Wear Rate (TWR), and Surface Roughness (SR). Process parameters that mostly affected the EDM Process are Pulse on Time, Pulse off Time, Discharge Current, Arc Gap and Duty Cycle. This paper reviews research for the optimization and improvement of various performance parameters measured in the experiment...

An empirical study on statistical analysis and optimization of EDM process parameters for inconel 718 super alloy using D-optimal approach and genetic algorithm

Among the several non-conventional processes, electrical discharge machining (EDM) is the most widely and successfully applied for the machining of conductive parts. In this technique, the tool has no mechanical contact with the work piece and also the hardness of work piece has no effect on the machining pace. Hence, this technique could be employed to machine hard materials such as super allo...

Multi-objective Optimization of Edm Parameters Using Grey Relation Analysis

This paper involves the multi-objective optimization of process parameters of AlSi10Mg/9 wt% alumina/3 wt% graphite in Electrical Discharge Machining for obtaining minimum surface roughness, minimum tool wear rate and maximum material removal rate. The important machining parameters were selected as peak current, flushing pressure and pulse-on time. Experiments were conducted by selecting diffe...