Multi-response optimization of machining factors in pocket milling of AISI304 using grey relational analysis
نویسندگان
چکیده
منابع مشابه
Multi-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملProcess parameters optimization on machining force and delamination factor in milling of GFRP composites using grey relational analysis
In this study, the optimization of process parameters for milling of glass fiber reinforced polymer (GFRP) composites using grey relational analysis has been investigated. Experiments are conducted using helix angle, spindle speed, feed rate, depth of cut and fiber orientation angle as typical process parameters. The grey relational analysis (GRA) is adopted to obtain grey relational grade for ...
متن کاملTaguchi-grey relational based multi response optimization of electrical process parameters in electrical discharge machining
In modern machining process, optimization technique is used to find the optimal values of input parameters and the effect of those parameters on response variables. If response parameters are more than one, Taguchi method of optimization may give different set of optimal levels for each response. In the present study, Taguchi-grey relational approach based multi response optimization has been u...
متن کاملOptimization of ECMAP parameters in production of ultra-fine grained Al1050 strips using Grey relational analysis
Production of lightweight metals with a higher strength to weight ratio is always the main goal of researchers. In this article, equal channel multi angular pressing (ECMAP) process as one of the most appealing severe plastic deformation (SPD) methods on production of ultra-fine grained (UFG) materials studied. Two main routes A and C investigated by FEM and compared with each other from differ...
متن کاملOptimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis
Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/1112/1/012006