Multiband Single-layer Frequency Selective Surface designed by Optimization Technique.
نویسندگان
چکیده
منابع مشابه
Single-Layer Bandpass Active Frequency Selective Surface
A single-layer, bandpass, active FSS is presented. It shows good angle of incidence stability for TE incidence, at the operating frequency of 2.45 GHz. It is based on circular loop aperture with each unit cell having four PIN diodes. A novel method for dc biasing is used. About 12 dB average variation in transmission loss, between ON and OFF states, has been experimentally achieved at 2.45 GHz.
متن کاملSingle - Layer Bandpass Active Frequency Selective Surface
If you believe this document infringes copyright then please contact the KAR admin team with the take-down information provided at http://kar.kent.ac.uk/contact.html Citation for published version Ghaffer, I Kiani. and Ford, Kenneth L. and Esselle, Karu P. and Weily, Andrew R. and Panagamuwa, C. and Batchelor, John C. (2008) Single-Layer Bandpass Active Frequency Selective Surface. Microwave an...
متن کاملPolarization Independent Triple-Band Single Layer Frequency Selective Structure
This paper deals with single layer polarization independent Frequency selective surface (FSS) which acts as a triple band reject filter. The two stop bands are broad with percentage bandwidth 11.16% and 10.13% and one is narrow with 3.33% bandwidth. The band ratio is more than 1.5 and band separation is around 30-35dB. This design is investigated theoretically by ANSOFT® Designer software and p...
متن کاملA Simple Synthesis Technique of Single- Square-loop Frequency Selective Surface
In this manuscript, a simple synthesis method of single square loop frequency selective surface (SSLFSS) is discussed, which may find the suitable application in the fast analysis and fabrication of the frequency-selective surface. The presented technique is used to design SSLFSS at 3 GHz, 15 GHz, 22GHz and 26GHz. At every frequency of interest, the analytical result is very close to the requir...
متن کاملGenetically Engineered Multiband High-impedance Frequency Selective Surfaces
A methodology is presented for the design synthesis of metamaterials that act as thin multifrequency artificial magnetic conductors. These structures are realized by placing a frequency-selective surface above a conventional prefect electric conductor, separated by a thin dielectric layer. The frequency-selective surface design is optimized using a microgenetic algorithm to operate at multiple,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Fundamentals and Materials
سال: 2003
ISSN: 0385-4205,1347-5533
DOI: 10.1541/ieejfms.123.253