Multifunctional porous catalyst produced by mechanical alloying
نویسندگان
چکیده
منابع مشابه
Raney-nickel Catalysts Produced by Mechanical Alloying
Raney catalysts were prepared by a combination of mechanical alloying and leaching as an alternative in the synthesis of Raney-Nickel catalysts. Binary Al-Ni and ternary Al-Ni-Fe alloys with nominal compositions Al65Ni35, Al75Ni25, Al65Ni30Fe5, Al75Ni20Fe5 (in atomic percent), were processed from pure elemental powders; they consisted mainly of the intermetallic B2 AlNi phase. Aluminum was sele...
متن کاملInvestigation on Mechanical and Electrical Properties of Cu-Ti Nanocomposite Produced by Mechanical Alloying
In this paper, Cu-Ti nanocomposite synthesized via ball milling of copper-titanium powders in 1, 3, and 6 of weight percentage compounds. The vial speed was 350 rpm and ball to powder weight ratio kept at 15:1 under Argon atmosphere, and the time of milling was 90 h. Obtained powders were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), and dynamic light scattering (DLS)....
متن کاملAging of a nanostructured Zn50Se50 alloy produced by mechanical alloying
The aging of a nanocrystalline equiatomic ZnSe alloy produced by mechanical alloying was investigated using X-ray diffraction (XRD) and differential scanning calorimetry (DSC) techniques. The measured XRD patterns showed that Se atoms located at interfacial component migrated with aging giving raise to a crystalline selenium (c-Se) phase. DSC spectra of heat-treated samples at temperatures abov...
متن کاملThermoelectric performance of lanthanum telluride produced via mechanical alloying
Andrew F. May,1 Jean-Pierre Fleurial,2 and G. Jeffrey Snyder3 1Department of Chemical Engineering, California Institute of Technology, 1200 East California Boulevard, Pasadena, California 91125, USA 2Jet Propulsion Laboratory, California Institute of Technology, 4800 Oak Grove Drive, Pasadena, California 91109, USA 3Department of Materials Science, California Institute of Technology, 1200 East ...
متن کاملStructural study of Cu(2-x)Se alloys produced by mechanical alloying.
The crystalline structures of the superionic high-temperature copper selenides Cu(2-x)Se (0 < x < 0.25) produced using mechanical alloying were investigated using X-ray diffraction (XRD). The measured XRD patterns showed the presence of peaks corresponding to the crystalline superionic high-temperature alpha-Cu(2)Se phase in the as-milled sample, and its structural data were determined by means...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research Letters
سال: 2019
ISSN: 2166-3831
DOI: 10.1080/21663831.2018.1561536