Multilayer Diamond Coatings Applied to Micro-End-Milling of Cemented Carbide
نویسندگان
چکیده
منابع مشابه
Diamond coatings for micro end mills: Enabling the dry machining of aluminum at the micro-scale
We show that thin diamond coatings can dramatically enhance the performance of micrometer-scale cutting tools. We present a new approach for coating 300 μm diameter tungsten carbide (WC) micro endmills using a tailored seeding method and hot filament chemical vapor deposition (HFCVD) to obtain uniform, conformal, and continuous diamond coatings less than 2 μm in both thickness and grain size. T...
متن کاملCutting Force Prediction in End Milling Process of AISI 304 Steel Using Solid Carbide Tools
In the present study, an attempt has been made to experimentally investigate the effects of cutting parameters on cutting force in end milling of AISI 304 steel with solid carbide tools. Experiments were conducted based on four factors and five level central composite rotatable design. Mathematical model has been developed to predict the cutting forces in terms of cutting parameters such as he...
متن کاملFabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling
This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...
متن کاملDevelopment of Creep-Resistant Tungsten Carbide Copper Cemented Carbide
Fine-grained tungsten carbide copper (WC-Cu) cemented carbide was sintered via spark plasma sintering at 1773K using a fine WC powder with a mean particle size of 0.11 mm. The mechanical properties were compared with tungsten carbide cobalt (WC-Co) cemented carbide and a binderless WC-sintered material. The Vickers hardness and fracture toughness obtained by the indentation fracture method for ...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2021
ISSN: 1996-1944
DOI: 10.3390/ma14123333