MULTILAYERED FILTER PROTECTIONS WITH DIFFERENT RIPRAP SIZES AGAINST LOCAL SCOUR OF SAND BED

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Riprap Stability: Transverse and Longitudinal versus Continuous Protections

An experimental study was conducted to determine the influence of length, width, and protrusion of noncontinuous riprap protections on shear failure conditions. The incipient motion of particles as a failure criterion and the reference transport method as the threshold of motion were used. In each test, riprap transport rates were measured at different time intervals using a sediment trap place...

متن کامل

Riprap sizing for scour protection at river confluence

River confluence is a common feature of most irrigation and drainage channels and river systems, where tributary conflicts the main channel. In these section, rapid changes in velocity and discharge, sediment distribution and flow turbulent result in a deep confluence scour, a bar point in the separation zone at downstream of junction corner  and finally vortex flow. Thus, the main goal of this...

متن کامل

Experimental Study for Protection of Piers Against Local Scour Using Slots

The most important causes of bridge failure are local scour. In this study, laboratory experiments were conducted to investigate the effectiveness of slot as a protection device in reduction of depth of scour at cylindrical piers under clear water flow conditions. The development time of scour depth at the circular pier with and without a slot as a protection device was conducted. The experimen...

متن کامل

Scour Caused by Three-Dimensional Submerged Square Wall Jet: Sand Deposition in Scour Hole and Ridge

Laboratory tests were carried out to assess the local scour by three-dimensional wall jets from a square crosssection nozzle. To this end, three different tailwater depths were used and the jet expansion ratio was held greater than ten. Velocity measurements were conducted using a one component laser Doppler anemometer. The jet exit Reynolds number was maintained to 1x10 and this value can be c...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Doboku Gakkai Ronbunshu

سال: 1997

ISSN: 0289-7806,1882-7187

DOI: 10.2208/jscej.1997.572_1