Nanoparticles for Ceramic and Nanocomposite Processing
نویسندگان
چکیده
منابع مشابه
simulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولUniformly Porous Nanocrystalline CaMgFe1.33Ti3O12 Ceramic Derived Electro-Ceramic Nanocomposite for Impedance Type Humidity Sensor
Since humidity sensors have been widely used in many sectors, a suitable humidity sensing material with improved sensitivity, faster response and recovery times, better stability and low hysteresis is necessary to be developed. Here, we fabricate a uniformly porous humidity sensor using Ca, Ti substituted Mg ferrites with chemical formula of CaMgFe1.33Ti₃O12 as humidity sensing materials by sol...
متن کاملMechanochemically Synthesized Metallic-Ceramic Nanocomposite; Mechanisms and Properties
Solid state chemical reaction is attributed to the chemical reaction performed at temperature which reactants are solid. In most solid state chemical reactions the reaction volume continually diminishes as the reactants become spatially separated by the products. As a result, the kinetics of solid state chemical reactions are limited by the rate at which reactant species are able to diffuse acr...
متن کاملCeramic Capillary Suspensions: Novel Processing Route for Macroporous Ceramic Materials
We introduce a novel method to produce macroporous ceramics by capillary suspensions. Adding a small amount (~1 vol%) of an immiscible secondary phase to a low concentration (~20 vol%) suspension can increase the yield stress by several orders of magnitude. This drastic change in flow behavior is induced by the creation of a sample-spanning particle network in the suspension controlled by capil...
متن کاملSuspension of nanoparticles in SU-8: Processing and characterization of nanocomposite polymers
Composite materials consisting of polymers and nanoparticles can provide additional functionality to existing formulations. Diamondoids, single-wall carbon nanotubes (SWNT), and gold nanospheres were physically incorporated into the negative photoresist SU-8 to investigate their effects on residual stresses and introduce piezoresistivity. The mixtures were spin cast onto silicon or aluminumcoat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Molecular Crystals and Liquid Crystals Science and Technology. Section A. Molecular Crystals and Liquid Crystals
سال: 2000
ISSN: 1058-725X
DOI: 10.1080/10587250008025657