Nickel-Based Alloy Dry Milling Process Induced Material Softening Effect
نویسندگان
چکیده
منابع مشابه
Influence of Process Parameters on Residual Stresses Induced by Milling of Aluminum Alloy Using Taguchi’s Techniques
In this paper, the straight flute end-milling cutter used for machining of Al-Si-Mg-Fe alloy work pieces was investigated. The machining processes could induce residual stresses that enhance greatly the performance of the machined component. Machining residual stresses correlate very closely with the cutting parameters. In the experiments, the residual stress on the surface of workpiece was mea...
متن کاملOptimization of Surface Roughness Using Taguchi Method for Dry Machining In Milling Process of Alloy Special Steel
In machining to improve machinability, productivity and to extend tool life coolants and lubricants where used .Increasing industry the use of cutting fluids subsequently increasing this leads in reduce of living conditions nearby future all the governments recommend the manufacturers to reduce the usage of toxicity cutting fluids. Still research for dry machining challenge is exiting for the i...
متن کاملInvestigation on Effect of Material Hardness in High Speed CNC End Milling Process
This research paper analyzes the effects of material properties on surface roughness, material removal rate, and tool wear on high speed CNC end milling process with various ferrous and nonferrous materials. The challenge of material specific decision on the process parameters of spindle speed, feed rate, depth of cut, coolant flow rate, cutting tool material, and type of coating for the cuttin...
متن کاملProcess Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy
The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and basal plane crystallographic texture, which significantly improve the corrosion resistance of magnesium alloy. These studies have focused on the positive effects of cryogenic coo...
متن کاملEmotional Learning Based Intelligent Controller for MIMO Peripheral Milling Process
During the milling process, one of the most important factors in reducing tool life expectancy and quality of workpiece is the chattering phenomenon due to self-excitation. The milling process is considered as a MIMO strongly coupled nonlinear plant with time delay terms in cutting forces. We stabilize the plant using two independent Emotional Learning-based Intelligent Controller (ELIC) in par...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13173758