Nitrogen-induced Phase Transformation in Type 304 Austenitic Stainless Steel
نویسندگان
چکیده
منابع مشابه
Experimental Quantification of Phase Transformation in Austenitic Stainless Steel
This conference paper briefly discusses different techniques for measuring the evolution of the martensite content in cold-rolled stainless steel 301LN sheets under mechanical loading. Three methods are employed to measure the martensite content: (1) micrography, (2) bulk magnetic induction, and (3) local magnetic permeability measurements. The first two methods require the extraction of sample...
متن کاملMartensite ? austenite phase transformation kinetics in an ultrafine-grained metastable austenitic stainless steel
A generalized phase transformation kinetics model is used to understand the martensite to austenite transformation in a cold-rolled and annealed metastable AISI 301LN ultrafine-grained austenitic stainless steel. The model shows that the presence of interstitial nitrogen and heavy cold-rolling is important to promote fast transformation kinetics, through rapid nitrogen-diffusion and austenite n...
متن کاملCompressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers
Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...
متن کاملRadiation-induced Segregation and Void Swelling in 304 Stainless Steel
. Void swelling and radiation-induced segregation have been measured in 304 stainless steel. Samples were irradiated in the outer regions of the EBR-11reactor where displacement rates of 2.OX10-8and 6.6 xl 0-8dpds are comparable to those in pressurized water reactor components. Samples were inadiated at temperatures from 371-390°C to total doses of up to 20 dpa. Void swelling reached a maximum ...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1986
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.50.4_362