Non-Contact Energy Transfer System Using Immittance Converter
نویسندگان
چکیده
منابع مشابه
Hybrid Energy System using Three Port Converter
Three Port Converters are used for merging more than a single source in order to improve the power handling capability. Here the first two ports acts as the sources and the third port acts as the output or to the Load. The objective is combining the Wind Energy Systems with the Existing Three Port Converter System instead of a Battery Storage. The proposed system is simulated and verified using...
متن کاملSimple Floating Immittance Simulator Using Single DVCCTA
This paper presentes a simple floating immittance simulation circuit employing only one differential voltage current conveyor transconductance amplifier (DVCCTA) and two grounded passive components. The proposed floating simulator circuit can realize floating inductor, capacitor or resistor depending on the passive element selection. The equivalent value of the realized simulator can be tuned e...
متن کاملNonlinear control of flap-type wave energy converter with a non-ideal power take-off system
Wave energy converters (WECs) require active control to maximise energy capture over a wide range of sea conditions, which is generally achieved by making the device resonate. The exaggerated device motion arising at resonance, however, may result in nonlinear effects that are ignored by the linear models that are typically employed. In particular, nonlinear viscous forces are significant for p...
متن کاملNew General Immittance Converter JFET Voltage-Controlled Impedances and Their Applications to Controlled Biquads Synthesis
Two new general immittance converter (GIC) JFET configurations for the realization of voltage-controlled impedances (VCI’s) are proposed. Compared with previously reported structures, the circuits exhibit wide dynamic range and low distortion properties that are frequency independent, even for nonresistive VCI’s. We consider the influence of op-amps frequency dependent gain and derive condition...
متن کاملModeling and Optimization of Capacitive Converter for Energy Scavenging System
A new converter with spherical cap for energy scavenging is proposed. Based on the method of separated variables within the torrid coordinate system, a corresponding analytical model for spherical cap converter is further established so as to obtain the analytic expressions of the topology capacitance and the output voltage. The concept of energy increment factor is specifically defined to deno...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Industry Applications
سال: 2000
ISSN: 0913-6339,1348-8163
DOI: 10.1541/ieejias.120.789