Non-isothermal experimental and simulation study of residual wall thickness in gas assisted injection moulding
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Experimental and Numerical Pore Scale Study of Residual Gas Saturation in Water/Gas Imbibition Phenomena
Residual gas saturation is one of the most important parameter in determining recovery factor of water-drive gas reservoir. Visual observation of processes occurring at the pore level in micromodels can give an insight to fluid displacements at the larger scale and also help the interpretation of production performance at reservoir scale. In this study experimental tests in a glass micromod...
متن کاملSimulation Tools for Injection Moulding
In this paper the concern is certain simulation tools for the lling phase of injection moulding of plastics. A mathematical model, called the distance model, of the injection moulding process has been developed by Professor Gunnar Aronsson at the University of Linkk oping. From this model one can nd the lling pattern (i.e. ow fronts) of the molten polymer as it enters the mould, by solving a sh...
متن کاملExperimental and Simulation - Assisted Feasibility Study of Gas Injection to Increase Oil Recovery Using a Combination of Semi-VAPEX and GAGD Techniques
Gas injection into heavy oil reservoirs could result in high ultimate recovery of oil. Experimental studies showed that an application of a combined technology of Gas Assisted Gravity Drainage (GAGD) and Vapor Extraction (VAPEX) could increase final oil recovery of a candidate viscous oil reservoir. In this paper the results of laboratory investigation are presented, including Pressure-Volu...
متن کاملFabrication of Thin Cavities with Gas Assisted Injection Moulding: Experiments and Simulations
Despite some pitfalls in the practical application of the gas assisted injection moulding (GAIM) process, it offers a number of advantages over conventional injection moulding. However, its inherent complexity requires an advanced control over several additional parameters. This study is preliminar to examine the gas void and its relation to channel geometry and processing conditions for differ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Plastics, Rubber and Composites
سال: 2006
ISSN: 1465-8011,1743-2898
DOI: 10.1179/174328906x79969