Non-Linear Frequency Noise Modulation in a Resonant MEMS Accelerometer
نویسندگان
چکیده
منابع مشابه
Noise Analysis and Noise-based Optimization for Resonant MEMS Structures
This paper presents a detailed noise analysis and noise-based optimization procedure for resonant MEMS structures. A design for high sensitivity of MEMS structures needs to take into account the noise shaping induced by damping phenomena at micro scale. The extraction of a behavioral model of the solid gas interaction is obtained by matching the FEA simulations with a parametric expression for ...
متن کاملA Modular Mems Accelerometer Concept
Presently, main applications can be found in the automotive market segment (e.g. front and side airbag sensors, ESP respectively chassis stabilization, active suspension, roll over detection). However, low-g sensors enter also new application areas like inclinometry and vibration sensing for instance for anti-theft devices or activity monitoring for pacemaker control. Like in the microelectroni...
متن کاملMEMS Accelerometer Readout
You work in a characterization laboratory af a MEMS company, and you have to design an electronic board in order to test a given capacitive accelerometer. The application of the sensor is vibration monitoring on a mechanical engine in a specific frequency range (from 40 Hz to 400 Hz). The MEMS device has a mass of 8nK g , a mechanical stiffness of 5N /m and a quality factor Q = 2. The capacitiv...
متن کاملA Low-Noise DC Seismic Accelerometer Based on a Combination of MET/MEMS Sensors
Molecular-electronic transducers (MET) have a high conversion coefficient and low power consumption, and do not require precision mechanical components thus allowing the construction of cost- and power-efficient seismic accelerometers. Whereas the instrumental resolution of a MET accelerometer within the 0.1-100 Hz frequency range surpasses that of the best Micro-Electro Mechanical Systems (MEM...
متن کاملA 1 mG lateral CMOS-MEMS accelerometer
This paper reports a lateral CMOS-MEMS accelerometer with a measured noise floor of 1mG/ and a dynamic range larger than 13G. The accelerometer is fully compatible with conventional CMOS processes enabling the integration of most of the conditioning circuits. It is fabricated in a three metal layer 0.5μm CMOS process followed by a two-step dry etch release. An improved curl matching technique i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Sensors Journal
سال: 2017
ISSN: 1530-437X,1558-1748,2379-9153
DOI: 10.1109/jsen.2017.2703156