Non-Linear Spring Characteristics and Stresses of Rectangular Wire Helical Springs with a Continuously Changing Wire Cross Section.
نویسندگان
چکیده
منابع مشابه
Sensitivity Analysis and Stray Capacitance of Helical Flux Compression Generator with Multi Layer Filamentary Conductor in Rectangular Cross-Section
This paper presents an approach to calculate the equivalent stray capacitance (SC) of n-turn of the helical flux compression generator (HFCG) coil with multi layer conductor wire filaments (MLCWF) in the form of rectangular cross-section. This approach is based on vespiary regular hexagonal (VRH) model. In this method, wire filaments of the generator coil are separated into many very small simi...
متن کاملFree vibration of rectangular plates with continuously distributed spring-mass
The vibratory characteristics of rectangular plates attached with continuously and uniformly distributed spring-mass in a rectangular region are studied which may represent free vibration of a human–structure system. Firstly, the governing differential equations of a plate with uniformly distributed spring-mass are developed. When the spring-mass fully occupies the plate, the natural frequencie...
متن کاملInvestigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
متن کاملon the effect of linear & non-linear texts on students comprehension and recalling
چکیده ندارد.
15 صفحه اولA Monofilar Spiral Antenna Excited Through a Helical Wire
The radiation characteristics of a monofilar spiral antenna excited through a helical wire are investigated using the method of moments. The spiral has a circumference of more than two wavelengths (2.3 , where is the wavelength at a test frequency of 6 GHz) to obtain a tilted beam. An input impedance of approximately 50 is realized by appropriately selecting the diameter and pitch angle of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2002
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.68.1438