Nondestructive in situ thermoluminescence using CO_2 laser heating
نویسندگان
چکیده
منابع مشابه
Nondestructive evaluation of cylindrical parts using laser ultrasonics.
We applied the laser ultrasonic technique for detecting surface breaking slots in steel cylinders (25 mm in diameter). The observation of the detected signal over a long time (500 micros), shows that the interaction of the two contra-propagating incident Rayleigh waves reinforce the echoes coming from the defect. These echoes are slowly growing with time whereas the main signals decrease. This ...
متن کاملRecovery of thermoluminescence sensitivity in CaF2:Mn (TLD-400) dosimeter under heating process
In order to recovery the thermoluminescence (TL) sensitivity of CaF2:Mn (TLD-400) thermoluminescent dosimeter it was exposed to high gamma radiation dose of 10kGy, then by applying standard annealing followed by irradiation to 1Gy gamma dose, the TL signal was recorded . The TL response reduced due to the damage effect of high dose irradiation in comparison with control dosimeter with received ...
متن کاملNondestructive Sensor Using Microwaves from a Laser Plasma
Ground penetrating radar (GPR) is a nondestructive sensor technology for detecting underground objects. GPR requires large-aperture antennas to survey a remote location precisely because of the expansion of microwaves. We propose a laser-driven GPR (LGPR) that uses microwave radiation from a laser plasma to achieve remote sensing. LGPR is expected to provide good spatial resolution with a small...
متن کاملIn situ laser heating and radial synchrotron x-ray diffraction in a diamond anvil cell.
We report a first combination of diamond anvil cell radial x-ray diffraction with in situ laser heating. The laser-heating setup of ALS beamline 12.2.2 was modified to allow one-sided heating of a sample in a diamond anvil cell with an 80 W yttrium lithium fluoride laser while probing the sample with radial x-ray diffraction. The diamond anvil cell is placed with its compressional axis vertical...
متن کاملLaser Pulse Heating
Recently, interest has developed in pulsed heating effects on a copper surface[1]. Pulsed heating is one of the limits on the gradient of a structure based linac. The heat generated by an intense RF pulse on the metal surface can result in hundreds of degrees of temperature rise at 1 GeV/m. After a certain number of cycles, the metal may crack due to thermal fatigue and the surface properties m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2002
ISSN: 1094-4087
DOI: 10.1364/oe.10.000291