NSM technique to increase the load carrying capacity of continuous RC slabs
نویسندگان
چکیده
منابع مشابه
Strengthening of Existing RC Two-Way Slabs using New Combined FRP fabric/rod Technique
This study presents the results of an experimental program to investigate the effectiveness of an innovative combined FRP technique using combination of externally bonded (EB) FRP fabrics and near surface mounted (NSM) FRP rods for flexural strengthening of existing reinforced concrete (RC) two-wayslabs with low clear cover thickness. Three full-scale RC slabs (1500×1500×120 mm) were tested und...
متن کاملLoad Carrying Capacity of Simply Supported Variable Thickness Circular Plates
The calculation of the load carrying capacity of variable thickness circular plates subjected to arbitrary rotational symmetric loading is presented. The analysis considers plate materials that obey either the square or the Tresca yield criterion. By using upper and lower bound theorems of limit analysis, corresponding estimations for the load carrying capacity of the plate are obtained. It is ...
متن کاملOptimal Trajectory of Flexible Manipulator with Maximum Load Carrying Capacity
In this paper, a new formulation along with numerical solution for the problem of finding a point-to-point trajectory with maximum load carrying capacities for flexible manipulators is proposed. For rigid manipulators, the major limiting factor in determining the Dynamic Load Carrying Capacity (DLCC) is the joint actuator capacity. The flexibility exhibited by light weight robots or by robots o...
متن کاملload carrying system characteristics of existing turkish rc building stock
seismic performance and loss assessment studies for stock of buildings are generally based on representative models due to extremely large number of vulnerable buildings. the main problem is the proper reflection of the building stock characteristics well enough by limited number of representative models. this study aims to provide statistical information of structural parameters of turkish bui...
متن کاملEffect of Shear Resistance on Flexural Debonding Load-Carrying Capacity of RC Beams Strengthened with Externally Bonded FRP Composites
Debonding failure is the main failure mode in flexurally strengthened reinforced concrete beams by externally bonded or near surface mounted fibre reinforced polymer (FRP) composites. It is believed that FRP debonding will be initiated if the shear stress on the concrete-FRP interface reaches the tensile strength of concrete. However, it was found through experimental and analytical studies tha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Structures
سال: 2013
ISSN: 0141-0296
DOI: 10.1016/j.engstruct.2013.04.021