Nucleation and Growth Process of Sticking Particles in Ferritic Stainless Steel.
نویسندگان
چکیده
منابع مشابه
Precipitation sequence in niobium-alloyed ferritic stainless steel
Niobium is an important alloying element in the design of heat-resistant ferritic stainless steels for automotive exhaust systems. When in solid solution, it improves both the high temperature strength and the resistance to thermal fatigue. However, it also forms several kinds of precipitates during service. These reactions have been modelled, taking into account the multicomponent nature of th...
متن کاملThe Influence of Homogenization and Solution Annealing Process on the Microstructure and Mechanical Properties of 1.4470 Ferritic-austenitic Stainless Steel
In the present research, the effect of the homogenization process and annealing temperature were investigated for the 1.4470 ferritic-austenitic stainless steel in the as-cast condition. In this regard, microstructural evolutions, hardness, and impact energy of the steel was evaluated with different heat treatment conditions. The results show that the minimum volume fraction of austenite phase ...
متن کاملExternal corrosion resistance of steel and ferritic stainless steel exhaust systems
The exhaust system has a number of requirements to fulfil. The major ones are to reduce the noise level created by the engine, to channel the waste gases out the rear of the automobile, to minimize the reduction in engine performance, and to have an acceptable service life and cost1. The exhaust system is divided into two main parts, the hot end and the cold end. The components comprising the h...
متن کاملElectrochemical and passivation behavior investigation of ferritic stainless steel in simulated concrete pore media
The applications of stainless steel are one of the most reliable solutions in concrete structures to reduce chloride-induced corrosion problems and increase the structures service life, however, due to high prices of nickel, especially in many civil engineering projects, the austenitic stainless steel is replaced by the ferritic stainless steels. Compared with austenite stainless steel, the fer...
متن کاملInvestigation of Diamond Deposition on AISI 316 & 430 Stainless Steel Substrares
In this paper, the nucleation and growth of diamond/diamond-like coatings on austenitic (AISI 316) and ferritic (AISI 430) stainless steel substrates have been investigated using torch technique. The effects of substrate surface preparation has also been studied. The quality of coatings produced has been examined using optical and scanning electron microscopy, X-ray diffraction, Raman spectros...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2000
ISSN: 0915-1559
DOI: 10.2355/isijinternational.40.789