Numerical Analysis on Compressive Deformation Behavior of Porous Polymer with High Initial Relative Density
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملInfluence of Initial Microstructure on Hot Deformation Behavior of Duplex Stainless Steels
In this research the effect of initial microstructure on hot deformation behavior in terms of Ferrite-to-Austenite ratios is studied. Two types of stainless steels C1 and C2 were homogenizing heat-treated and deformed under hot compression examinations at temperatures 900ºC and 1100ºC at strain rate of 0.1s-1. The results showed that the flow stress levels of specimens are strongly r...
متن کاملFatigue Behavior of Polymer Modified Porous Concretes
Highly permeable materials provide drainage and noise absorption properties that are useful in pavement top-layers. In such porous concretes, the voids reduce the mechanical integrity, which may have to be compensated by the incorporation of non-conventional components, such as polymers. A basic property needed for the design of pavements is the fatigue behavior of the material, which has not b...
متن کاملUltra-porous titanium oxide scaffold with high compressive strength
Highly porous and well interconnected titanium dioxide (TiO(2)) scaffolds with compressive strength above 2.5 MPa were fabricated without compromising the desired pore architectural characteristics, such as high porosity, appropriate pore size, surface-to-volume ratio, and interconnectivity. Processing parameters and pore architectural characteristics were investigated in order to identify the ...
متن کاملUltra-high current density water management in polymer electrolyte fuel cell with porous metallic flow field
Anode dry-out is the main mechanism identified to limit operation in an open metallic element (OME) PEFC. The fundamental water transport mechanisms in the OME PEFC were examined in order to engineer further improved performance and higher temperature operation required for efficient heat rejection. Specifically, the net water drag (NWD) was measured over a range of conditions and analyzed with...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2007
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.56.647