Numerical Investigation of Deep Dynamic Stall for a Helicopter Blade Section
نویسندگان
چکیده
منابع مشابه
A Numerical Investigation on the Dynamic Stall of a Wind Turbine Section Using Different Turbulent Models
In this article, the flow behavior around a NACA 0012 airfoil which is oscillating with different Reynolds numbers and in various amplitudes has been investigated numerically. Numerical simulations have been performed with ANSYS software. First, the 2D geometry has been studied in different Reynolds numbers and angles of attack with various numerical methods in its static condition. This analys...
متن کاملNumerical Simulation of Dynamic Stall Phenomena in Axial Flow Compressor Blade Rows
This article explores the simulation of stall phenomena in axial compressor blade rows. The approach is based on the numerical solution of the compressible, two-dimensional Navier-Stokes equations. The results of both unforced and forced low-speed rotor stall are presented. In unforced cases, substantial ow separation is observed before the maximum pressure rise operating point is reached. Thes...
متن کاملNumerical Investigation of Rotating-Stall in a Stage of an Axial Compressor with Two Different Approaches
An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters and the two-layer Baldwin-Lomax turbulence model was also implemented. To validate the solver, two test cases were prepared and the computed results had good agreements with reference data. The rotating...
متن کاملWind Tunnel Testing of a Full Scale Helicopter Blade Section with an Upstream Active Gurney Flap
Wind tunnel tests were performed on an aerofoil section comparable to that of a full scale helicopter blade section with an upstream active Gurney flap in the framework of the European project CleanSky ITD Green RotorCraft. A modified NACA0012 profile was used, with 23 Kulite pressure transducers embedded in the profile’s surface and with an integrated actuator system for the Gurney flap. The G...
متن کاملElectrochemically-actuated Morphing Helicopter Blade
The use of the expansion of lithium-ion cells for mechanical actuation has been recently reported by Chin et. al. (1). Under a stress of 10 MPa, actuating strains of up to 1.5% were achieved. Taking into account the cells approximate elastic modulus, this strain corresponds to a mechanical energy density ten times higher than that of current piezoelectric materials, although with slower actuati...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIAA Journal
سال: 2019
ISSN: 0001-1452,1533-385X
DOI: 10.2514/1.j057686