منابع مشابه
Numerical Simulation of an Explosively Driven HVDC Circuit Breaker
High Voltage Direct Current (HVDC) circuit breakers have to suppress high values of currents at high voltages in absence of current-zero points. This makes the arc interruption more severe than the case of conventional AC networks. For circuit breaking in HVDC networks, a capacitor-inductor set has been inserted in parallel with the circuit breaker to inject reverse current to the interruption ...
متن کاملNumerical Modelling of the Segmental Lining of Underground Structures
There are several methods for analysing the behaviour of underground structures under different loading conditions. Most of these methods have many simplifications; therefore, in some cases, the results are too conservative and a very high safety factor, usually of more than 2 is needed. On the other hand, for stability analysis and the designing of support systems, these methods consider segme...
متن کاملNumerical modelling of induced rip currents by discontinuous submerged breakwaters
Submerged breakwaters are one of the shore protective structures. Any discontinuity in these breakwaters causes changes on current parameters including speed and water surface profile. In this paper, discontinuous submerged breakwaters were modelled to investigate the changes in the wave and flow pattern.To investigate the phenomenon, three models including a shore with constant slope, a shore ...
متن کاملNumerical Simulation and Optimization Design of the Annular Mechanical Foam Breaker
The annular foam breaker is one which uses the vacuum and shear force generated by the Coanda effect to break foam. The pressure distribution directly affects its performance. So an investigation on the flow characteristics inside the annular foam breaker is important to optimize its structure. In this paper, the computational fluid dynamics (CFD) code, FLUENT, is employed to simulate the flow ...
متن کاملNumerical Modelling of Backfill Grouting Approaches in EPB Tunneling
One of the main issues involved during tunnel construction with tunnel boring machines is the tail gap grouting. This gap is between the external diameter of tunnel lining and the excavation boundary that is filled with high-pressure grouting materials. In this work, three different approaches of gap grouting modeling in the FLAC3D software are investigated with a special attention to the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Coastal Engineering Proceedings
سال: 2017
ISSN: 2156-1028,0589-087X
DOI: 10.9753/icce.v35.waves.29