Numerical Optimization of a CPU Heat Sink Geometry
نویسندگان
چکیده
منابع مشابه
Optimization of the Geometry of a Heat Sink
Cellular materials have properties similar to conventional materials on the macroscopic level but possess several advantages at the microscopic level, including the ability to be manufactured down to a very small scale. With this ability, new geometric configurations for a heat sink are able to be considered. This paper details the results of a study to develop a geometry based optimization too...
متن کاملNumerical Optimization of Pin-Fin Heat Sink with Forced Cooling
This study presents the numerical simulation of optimum pin-fin heat sink with air impinging cooling by using Taguchi method. 9 L ( 4 3 ) orthogonal array is selected as a plan for the four design-parameters with three levels. The governing equations are discretized by using the control-volume-based-finite-difference method with a power-law scheme on the non-uniform staggered grid. We solved th...
متن کاملHeat Sink Performance Analysis through Numerical Technique
The increase in dissipated power per unit area of electronic components sets higher demands on the performance of the heat sink. Also if we continue at our current rate of miniaturisation, laptops and other electronic devices can get heated up tremendously. Hence we require a better heat dissipating system to overcome the excess heat generating problem of using nanoelectronics, which is expecte...
متن کاملA numerical investigation of heat transfer and pressure drop in a novel cylindrical heat sink with helical minichannels
This study numerically investigated heat transfer and fluid flow characteristics in a novel cylindrical heat sink with helical minichannels for the laminar flow of fluid with temperature-dependent properties. A finite volume method was employed to obtain the solution of governing equations. The effects of helical angle, channel aspect ratio, and Reynolds number, which were regarded as main para...
متن کاملNumerical optimization of a PCM-based heat sink with internal fins
This study presents an optimization procedure for the design of a Latent Heat Thermal Management System (LHTMS), used for cooling an electronic device with transient and high heat generation. The LHTMS consists of Phase Change Material (PCM) combined with internal fins, which are used for creating high conductive paths into the PCM. The optimization is performed with a sole aim of minimizing th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: CFD Letters
سال: 2021
ISSN: 2180-1363
DOI: 10.37934/cfdl.13.3.115