Numerical Study of Heat Transfer Enhancement in Contour Corrugated Channel Using Water and Engine Oil
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of Heat Transfer and Pressure Drop in a Corrugated Channel
The influence of variation in rib-height to channel-height ratio (e/H) on the heat transfer and pressure drop characteristics inside a channel with corrugated upper and lower plates was investigated numerically in the present study. The governing equations were solved by using finite volume approximations for a wide range of (0.06 < e/H < 0.26) and Reynolds numbers (5400 < Re < 23000), with a m...
متن کاملNumerical Comparison of Turbulent Heat Transfer and Flow Characteristics of SiO2/Water Nanofluid within Helically Corrugated Tubes and Plain Tube
Turbulent heat transfer in Helically Corrugated Tubes (HCT) was numerically investigated for pure water and SiO2 nanofluid using Computational Fluid Dynamics (CFD). This study was carried out for different corrugating pitches (5, 7, 8 mm) and heights (0.5, 0.75, 1.25 mm) at various Reynolds numbers ranging from 5000 to 13300. The effect of nanoparticles on heat transfer augmentation for plain t...
متن کاملNumerical study of fluid flow and heat transfer in a gas-tank water heater
Influence of a vent hood at the exit of exhaust flue gas and flue baffles in the firetube on the temperature and flow fields of a gas tank water heater, as well as thestructure and amount of heat transferred to the water tank has been studiednumerically using two-dimensional steady state finite element simulation.Observations show that without a vent hood, there is a downward gas flow in theflu...
متن کاملNumerical optimization of heat transfer enhancement in a wavy channel using nanofluids
7 8 Available online xxxx 9101 12
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: CFD Letters
سال: 2020
ISSN: 2180-1363
DOI: 10.37934/cfdl.12.12.1737