On a Creep Testing Machine and Creep Test Results on Low-Carbon Steel
نویسندگان
چکیده
منابع مشابه
SEM, TEM and SLEEM (scanning low energy electron microscopy) of CB2 steel after creep testing
The demand to produce electrical power with higher efficiency and with lower environmental pollution is leading to the use of new advanced materials in the production of power plant equipment. To understand the processes taking place in parts produced from these materials during their operation under severe conditions (such as high temperature, high stress, and environmental corrosion) requires...
متن کاملLecture 14 : Creep – Resistant Steel , Case Study
Introduction Typical operating parameters for steels used in the manufacture of power plant are compared against corresponding values for nickel alloys in aeroengines, in Table 1. In both cases, the service conditions are severe. But this is especially so for steels where the service life is many decades. The degree of reliability demanded of heat resistant steels is therefore extraordinary, an...
متن کاملthe relationship between eq, iq and test format: a study on test fairness
the major aim of this study was to investigate the relationship between iq, eq and test format in the light of test fairness considerations. this study took this relationship into account to see if people with different eq and iq performed differently on different test formats. to this end, 90 advanced learners of english form college of ferdowsi university of mashhad were chosen. they were ask...
15 صفحه اولA Study on Predicting the Long-term Creep Behavior of Plastics using the Short-term Creep Test
Abstract: The creep performance of plastics is one of the main criteria for a variety of applications with strict dimensional stability needs, including electrical/electronic parts and various automotive applications. However obtaining or generating accurate creep data is very difficult for both resin suppliers and product designers because the creep property is time dependent, which means it t...
متن کاملEvaluation of current methods for creep analysis and impression creep testing of power plant steels
Destructive testing of creep exposed components is a powerful tool for evaluation of remaining lifetime of high temperature pipe systems. The most common destructive evaluation method used today is uniaxial creep testing. Uniaxial creep tests can produce accurate creep curves but the test method has some drawbacks such as costliness and long testing times. It also demands large sample material ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: journal of the Japan Society for Testing Materials
سال: 1953
ISSN: 0372-7971
DOI: 10.2472/jsms1952.2.47