On-Chip Integrated Distributed Amplifier and Antenna Systems in SiGe BiCMOS for Transceivers with Ultra-Large Bandwidth
نویسندگان
چکیده
منابع مشابه
Self-Equalized Distributed Amplifier for Wide Band Optical Transceivers
A novel technique for a self-equalized distributed amplifier is presented by showing the analogy between transversal filters and distributed amplifier topologies. The appropriate delay and gain coefficients of amplifier circuit are obtained by a Fourier expansion of the raised cosine spectrum in the frequency range of 0-40GHz.
متن کامل65GHz Doppler Sensor with On-Chip Antenna in 0.18μm SiGe BiCMOS
A single-chip 65GHz Doppler radar transceiver with on-chip patch antenna is reported. Implemented in a production 0.18μm SiGe BiCMOS process, it features a differential output transmit power of 4.3dBm, 16.5dB singleended down-conversion gain and a double-sideband noise figure of 12.8dB. The radar includes a 65GHz 2-stage cascode LNA with S11<-15dB at 50-94GHz and 14dB gain at 65GHz, a double-ba...
متن کاملNoise Analysis of Ultra High Speed SiGe BiCMOS Track and Hold Amplifier for Fiber Optic Equalizer
Noise performance of the switched emitter follower (SEF) track and hold (TH) amplifier is analyzed. Simulations based on a commercial available 130 nm SiGe HBT process technology are implemented with the SpectreRF circuit simulator. It is shown that both the thermal noise and shot noise contribute to the TH amplifier (THA) at ultra high frequency. Simulations also locate the major noise contrib...
متن کاملAn 8 – 18 GHz Wideband SiGe BiCMOS Low Noise Amplifier
In this paper, an 8 – 18 GHz wideband low noise amplifier (LNA) with an active balun fabricated in a 0.13-μm SiGe BiCMOS technology was presented. The LNA achieves 16dB of gain with 1.5 dB variation over the 8GHz to 18 GHz frequency band and a matched input with less than -9 dB of reflection. The minimum noise figure (NF) is 5 dB at 8GHz and increases to 6 dB at 18GHz. The measured IIP3 is -15-...
متن کاملUltra-Widband Distributed Amplifier Using Loss Compensation Technique on Both Input and Output Circuit
In this paper, we analyze a distributed amplifier based on input/output attenuation compensation. The analysis is carried out for a HEMT transistor; and a constant-k section filter is used to calculate the amplifier’s characteristics such as attenuation factor, phase constant and gain. The proposed design approach enables us to examine the tradeoff among the variables, which include the type an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Frequenz
سال: 2017
ISSN: 2191-6349,0016-1136
DOI: 10.1515/freq-2017-0155